FREE  STANDARD  SHIPPING                          15% OFF on all Orders over 100$

0

Your Cart is Empty

CARE INSTRUCTION

Maintaining and Storing Jack & Co.®  Stainless Steel Jewelry

Although stainless steel jewelry doesn’t tarnish or corrode and doesn’t require special care, it can scratch.

That’s why you should wear and store your pieces in a way that minimizes any contact with other items that can damage your stainless steel jewelry.

If your jewelry does get scratched, you can always have it professionally polished by a jeweler.

Store your stainless steel pieces separately from jewelry made of other metals. It is best if you keep your stainless steel items in individual bags or pouches.

Clean Your  Jack & Co.®  Stainless Steel

  • 1. Pour some warm water in a small bowl, and add some mild dishwashing soap. 
  • 2. Dip a soft, lint-free cloth in the soapy water, and then gently wipe the stainless steel jewelry with the damp cloth until the piece is clean.
  • When cleaning it, rub the item along its polish lines. 
  • 3. Wipe the remaining soap off your jewelry using a moist cloth dipped in clean water.
  • 4. Dry the jewelry well with a clean towel, and then leave your pieces to air dry.

    After your stainless steel jewelry is clean, you can use a jewelry polish or a polishing cloth to shine it.

    Some people use toothpaste to clean the especially dirty spots of their stainless steel pieces.

    Keep in mind, however, that toothpaste is abrasive. If you decide to use it for cleaning, make sure it is a non-whitening brand that does not contain silica, and use a soft cloth to rub the paste onto your pieces.

    Don’t forget to rinse the jewelry thoroughly after you are done.

    You can also buy a regular jewelry cleaner whose label says that it can be used on stainless steel.

    Jack & Co.®  925 Sterling Silver Care

    Silver will naturally tarnish when exposed to common everyday items that contain sulphur, such as leather, rubber, chlorine, salt water, and even air pollution.

    We think these designs look best with some character, but if you decide you want to keep your Jack & Co.  pieces looking shiny and new, simply polish them with a silver polishing cloth — these can be purchased at most fine jewelry stores. 
    **WHEN YOU BUY ANY OF OUR RINGS OR BRACELETS, YOU ARE Jacked'UP ®  FOR LIFE. THAT’S RIGHT. FOR. LIFE. (CLICK HERE TO FIND OUT MORE!)                                    


    Subscribe

    sizing chart

    The most common size
    The average women’s ring size is 7
    The average men’s ring size is 10

    How To Measure Your US Ring Size At Home
    1. Cut a thin paper or thread

    2. Wrap the thread around your finger. Make sure the thread is below the joint of 
    your finger and close to your knuckle.

    3. Mark the location where the thread meets and measure the distance with your ruler. Use millimeters to measure your circumference.

    4. Measure your fingers a few times to ensure the sizing is correct.

    5. Use the following chart above to determine your USA ring size.

    Measure a Ring You Already Have

    If you have a ring that already fits your finger well, you can use a ruler to measure the inside diameter of this ring. Just take your ruler and measure straight across the inside of the ring from edge to edge. Take the diameter measurement in millimeters, and then use our measurement-conversion chart to find your ring size.

    Measure a Ring You Already Have

    If you have a ring that already fits your finger well, you can use a ruler to measure the inside diameter of this ring. Just take your ruler and measure straight across the inside of the ring from edge to edge. Take the diameter measurement in millimeters, and then use our measurement-conversion chart to find your ring size.

    Get Jacked'UP®   (shop now )